|
| |
Receivers are made of 4130 moly seamless
steel. Each receiver comes with an accurate CAD drawn template bonded in
place. All specs. are on templates so that you can check your progress as you
work. Receivers are defined as follows:
Standard Receivers
 | Blank with template:
CAD drawn template bonded on. All work will need to be completed upon
purchase. |
| 75% Completed: We will
drill the rivet and vent holes for you. ALL mill work remains to be
completed by the purchaser. This includes the cocking handle slot, mag well,
and ejection port. |
| 80% Completed
(Sten): Cocking
handle slot has been cut, and vent holes have been drilled. All rivet
holes are drilled slightly undersize [.100]--Ream up to [.125] to achieve the
tightest fit using steel rivets. Or you can drill the holes to [.136],
tap 8 x 36 NF and use button head screws. The ejection port, sear port, and mag well must be finished by the buyer. |
Ventilated Receivers
| Blank with template:
Template includes precision specs. for cutting vent holes to resemble the
Sterling look. |
| 75% Completed:
Receiver comes with all rivet holes cut as well as the 35 vent holes.
All mill work remains to be completed by the buyer. |
| 80% Completed:
Receiver comes with all rivet holes cut as well as the 35 vent holes.
Cocking handle slot has been mill cut. The ejection port, sear port, and mag well must be finished by the buyer. |
Vertical
Receivers
|
Same variations apply as for the standard receivers. Each vertical
receiver comes with instructions to convert your bolt (blueprint/template).
We can convert your bolt for you--Check our "Services"
page for more information. |
Left Side Cocking
| Same
variations apply as for the standard and ventilated receivers. With this
version, there is no need to drill the bolt and relocate the cocking handle.
You will also get the added advantage of keeping your trigger hand in place
while being able to cock the weapon. |
|
